Sabtu, 28 April 2018

Sponsored Links

File:LR44 Button Cell Battery.jpg - Wikimedia Commons
src: upload.wikimedia.org

A watch battery or button cell is a small single cell battery shaped as a squat cylinder typically 5 to 25 mm (0.197 to 0.984 in) in diameter and 1 to 6 mm (0.039 to 0.236 in) high -- like a button on a garment, hence the name. A metal can forms the bottom body and positive terminal of the cell. An insulated top cap is the negative terminal.

Button cells are used to power small portable electronics devices such as wrist watches, pocket calculators, artificial cardiac pacemakers, implantable cardiac defibrillators, automobile keyless entry transmitters, and hearing aids. Wider variants are usually called coin cells. Devices using button cells are usually designed around a cell giving a long service life, typically well over a year in continuous use in a wristwatch. Most button cells have low self-discharge and hold their charge for a long time if not used. Higher-power devices such as hearing aids, where high capacity is important and low self-discharge less so as the cell will usually be used up before it has time to discharge, may use zinc-air cells which have much higher capacity for a given size, but dry out over a few weeks even if not used.

Button cells are single cells, usually disposable primary cells. Common anode materials are zinc or lithium. Common cathode materials are manganese dioxide, silver oxide, carbon monofluoride, cupric oxide or oxygen from the air. Mercuric oxide button cells were formerly common, but are no longer available due to the toxicity and environmental effects of mercury.

Cells of different chemical composition made in the same size are mechanically interchangeable. However, the composition can affect service life and voltage stability. Using the wrong cell may lead to short life or improper operation (for example, light metering on a camera requires a stable voltage, and silver cells are usually specified). Sometimes different cells of the same type and size and specified capacity in milliampere-hour (mAh) are optimised for different loads by using different electrolytes, so that one may have longer service life than the other if supplying a relatively high current.

Button cells are very dangerous for small children. Button cells that are swallowed can cause severe internal burns and significant injury or death.


Video Button cell



Properties of cell chemistries

Alkaline batteries are made in the same button sizes as the other types, but typically provide less capacity and less stable voltage than more costly silver oxide or lithium cells. They are often sold as cheap watch batteries, and bought by people who do not know the difference.

Silver cells may have very stable output voltage until it suddenly drops very rapidly at end of life. This varies for individual types; one manufacturer (Energizer) offers three silver oxide cells of the same size, 357-303, 357-303H and EPX76, with capacities ranging from 150 to 200 mAh, voltage characteristics ranging from gradually reducing to fairly constant, and some stated to be for continuous low drain with high pulse on demand, others for photo use.

Mercury batteries also supply a stable voltage, but are now banned in many countries due to their toxicity and environmental impact.

Zinc-air batteries use air as the depolarizer and have much higher capacity than other types, as they take that air from the atmosphere. Cell have seals against air which must be removed before use; cells will then dry out in a few weeks, regardless of use.

For comparison, the properties of some cells from one manufacturer of different types with diameter 11.6 mm and height 5.4 mm are listed:

  • Silver: capacity 200 mAh to an end-point of 0.9 V, internal resistance 5-15 ohms, weight 2.3 g
  • Alkaline (manganese dioxide): 150 mAh (0.9), 3-9 ohms, 2.4 g
  • Mercury: 200 mAh, 2.6 g
  • Zinc-air: 620 mAh, 1.9 g

Examining datasheets for a manufacturer's range may show a high-capacity alkaline cell with a capacity as high as one of the lower-capacity silver types; or a particular silver cell with twice the capacity of some particular alkaline cell. If the powered equipment requires a relatively high voltage (e.g., 1.3 V) to operate correctly, a silver cell with a flat discharge characteristic will give much longer service than an alkaline cell--even if it has the same specified capacity in mAh to an end-point of 0.9 V. If some device seems to "eat up" batteries after the original supplied by the manufacturer is replaced, it may be useful to check the device's requirements and the replacement battery's characteristics. For digital calipers, in particular, some are specified to require at least 1.25 V to operate, others 1.38 V.

In some ways the size is the most important property of a button cell: cells of different chemistry are to a considerable extent interchangeable. In practice only cells of fairly similar voltages are made in any given size; there is no "CR1154" 3 V lithium battery mechanically interchangeable with a 1.5 V silver or alkaline size 1154 cell. Use of a battery of significantly higher voltage than equipment is designed for can cause permanent damage, while use of a cell of the right voltage but unsuitable characteristics can lead to short battery life or failure to operate equipment.


Maps Button cell



Type designation

International standard IEC 60086-3 defines an alphanumeric coding system for "Watch batteries". Manufacturers often have their own naming system; for example, the cell called LR1154 by the IEC standard is named AG13, LR44, 357, A76, and other names by different manufacturers. The IEC standard and some others encode the case size so that the numeric part of the code is uniquely determined by the case size; other codes do not encode size directly.

Examples of batteries conforming to the IEC standard are CR2032, SR516, and LR1154, where the letters and numbers indicate the following characteristics.

Electrochemical system

The first letter in the IEC standard system identifies the chemical composition of the battery, which also implies a nominal voltage:

For types with stable voltage falling precipitously at end-of-life (cliff-top voltage-versus-time graph), the end-voltage is the value at the "cliff-edge", after which the voltage drops extremely rapidly. For types which lose voltage gradually (slope graph, no cliff-edge) the end-point is the voltage beyond which further discharge will cause damage to either the battery or the device it is powering, typically 1.0 or 0.9 V.

Common names are conventional rather than uniquely descriptive; for example, a cell despite being referred to as a silver [oxide] cell rather than alkaline, actually has an alkaline electrolyte.

L, S, and C type cells are today the most commonly used types in quartz watches, calculators, small PDA devices, computer clocks, and blinky lights. Miniature zinc-air batteries - P type - are used in hearing aids and medical instruments.

The second letter, R, indicates a round (cylindrical) form.

The standard only describes primary batteries. Rechargeable types made in the same case size will carry a different prefix not given in the IEC standard, for example some ML and LiR button cells use rechargeable lithium technology.

Package size

Package size of button batteries using standard names is indicated by a 2-digit code representing a standard case size, or a 3- or 4-digit code representing the cell diameter and height. The first one or two digits encode the outer diameter of the battery in whole millimeters, rounded down; exact diameters are specified by the standard, and there is no ambiguity; e.g., any cell with an initial 9 is 9.5 mm in diameter, no other value between 9.0 and 9.9 is used. The last two digits are the overall height in tenths of a millimeter.

Examples:

  • CR2032: lithium, 20 mm diameter, 3.2 mm height
  • SR516: silver, 5.8 mm diameter, 1.6 mm height
  • LR1154/SR1154: alkaline/silver, 11.6 mm diameter, 5.4 mm height. The two-digit codes LR44/SR44 are often used for this size

Some coin cells, particularly lithium, are available in versions to solder into a circuit (typically to power very low current semiconductor memory ICs with configuration information for a device, for years), with different versions for vertical or horizontal mounting. The complete nomenclature will have prefixes and suffixes to indicate special terminal arrangements. For example, there is a plug-in and a solder-in CR2032, a plug-in and three solder-in BR2330s in addition to CR2330s, and many rechargeables in 2032, 2330, and other sizes.

Letter suffix

After the package code, the following additional letters may optionally appear in the type designation to indicate the electrolyte used:

  • P: potassium hydroxide electrolyte
  • S: sodium hydroxide electrolyte
  • No letter: organic electrolyte
  • W: the battery complies with all the requirements of the international IEC 60086-3 standard for watch batteries.

Other package markings

Apart from the type code described in the preceding section, watch batteries should also be marked with

  • the name or trademark of the manufacturer or supplier;
  • the polarity (+);
  • the date of manufacturing.

Date codes

Often a 2-letter code (sometimes on the side of the battery) where the first letter identifies the manufacturer and the second is the year of manufacture. For example:

  • YN - the letter N is the 14th letter in the alphabet - indicates the cell was manufactured in 2014.

There is no universal standard.

The manufacturing date can be abbreviated to the last digit of the year, followed by a digit or letter indicating the month, where O, Y, and Z are used for October, November and December, respectively (e.g., 01 = January 1990 or January 2000, 9Y = November 1999 or November 2009).

Common manufacturer code

A code used by some manufacturers is AG (alkaline) or SG (silver) followed by a number, where 1 equates to standard 621, 2 to 726, 3 to 736, 4 to 626, 5 to 754, 6 to 920 or 921, 7 to 926 or 927, 8 to 1120 or 1121, 9 to 936, 10 to 1130 or 1131, 11 to 721, 12 to 1142, and 13 to 1154. To those familiar with the chemical symbol for silver, Ag, this may suggest incorrectly that AG cells are silver.


Illinois Poison Center Blog » Blog Archive » The dangerous item ...
src: ipcblog.org


Common applications


LiR CR2032 40mAh 3.6V Protected 0.012A Lithium Ion (Li-Ion) Coin ...
src: 0497855326109438fada-869f30a49ddc9fde219928cc358ba5a0.ssl.cf2.rackcdn.com


Rechargeable variants

In addition to disposable (single use) button cells, rechargeable batteries in many of the same sizes are available, with lower capacity than disposable cells. Disposable and rechargeable batteries are manufactured to fit into a holder or with solder tags for permanent connection. In equipment with a battery holder, disposable or rechargeable batteries may be used, if the voltage is compatible.

A typical use for a small rechargeable battery (in coin or other format) is to back up the settings of equipment which is normally permanently mains-powered, in the case of power failure. For example, many central heating controllers store operation times and similar information in volatile memory, lost in the case of power failure. It is usual for such systems to include a backup battery, either a disposable in a holder (current drain is extremely low and life is long) or a soldered-in rechargeable.

Rechargeable NiCd button cells were often components of the backup battery of older computers; non-rechargeable lithium button cells with a lifetime of several years are used in later equipment.

Rechargeable batteries typically have the same dimension-based numeric code with different letters; thus CR2032 is a disposable battery while ML2032, VL2032 and LIR2032 are rechargeables that fit in the same holder if not fitted with solder tags. It is mechanically possible, though hazardous, to fit a disposable battery in a holder intended for a rechargeable; holders are fitted in parts of equipment only accessible by service personnel in such cases.


Energizer 393 Silver Oxide Watch Batteries - BatteryJunction.com
src: 0497855326109438fada-869f30a49ddc9fde219928cc358ba5a0.ssl.cf2.rackcdn.com


Health issues

In large metropolitan regions small children are directly impacted by the improper disposal of button cell type batteries, with Auckland in NZ getting about 20 cases per year requiring hospitalization.

Small children are likely to swallow button cells, which are somewhat visually similar to sweets, often causing fatalities. In Greater Manchester, England, with a population of 2,700,000, has had two children between 12 months and six years old that have died and five suffered life-changing injuries in the 18 months leading up to October 2014. Coin cells of diameter 20 mm or greater cause the most serious injuries, even if not crushed.

Mercury or cadmium

Some button cells contain mercury or cadmium, which are toxic. In early 2013 the European Parliament Environment Committee voted for a ban on the export and import of a range of mercury-containing products such as button cells and other batteries to be imposed from 2020.

Lithium

Lithium cells, if ingested, are highly dangerous. The damage is caused, not by the contents of the battery, but by the electric current it creates, which causes sodium hydroxide (caustic soda) to build up and burn through the oesophagus and into major blood vessels, which can cause fatal bleeding. Central Manchester University Hospital Trust warns that "a lot of doctors are unaware that this can cause harm".


set of lithium button cell batteries on white background Stock ...
src: c8.alamy.com


Counterfeits

There are many counterfeit batteries of all types, including button cells, branded and packaged as the product of a reliable manufacturer. They are often sold at a small fraction of the wholesale price of the genuine battery, although a higher price is not a guarantee of legitimacy. Many are poorly packaged, for example in simple blisters fixed on a cardboard backing where genuine ones are better-packaged. Reputable manufacturer Maxell says, without going into detail, that they are aware of fakes. They warn that they can cause injury and damage, and ask that they be contacted about fakes. In a great many forums on Amazon and similar e-commerce sites there are insistent and repeated reports of batteries that fail after a very short time; the consumer reviews usually show a very high proportion of favourable reviews ("arrived very promptly ... work OK ... very cheap"), but a significant number of longer-term reviews give the lowest rating. Reviews of this nature are not considered reliable sources, but these reports are very widespread.

One company has investigated Sony-branded watch and coin batteries in particular, and report that the most counterfeited include CR2032, CR2025, CR2016, SR626SW (377), and SR621SW (364). They show comparison photographs of card-packed real and counterfeit batteries on their Web site; they are very similar.


LIR2032 3.6V Button Coin Cell Rechar (end 5/4/2019 10:15 PM)
src: c.76.my


See also

  • List of battery sizes
  • List of battery types
  • Battery recycling
  • Artificial cardiac pacemaker
  • Implantable cardioverter-defibrillator

Button cell batteries for electronic devices - various sizes Stock ...
src: c8.alamy.com


References


SKILCRAFT 3V Lithium Button Cell Battery - Walker's Office Supplies
src: content.etilize.com


Notes


Button Cell Phone Icon Royalty Free Cliparts, Vectors, And Stock ...
src: previews.123rf.com


External links

  • Coin Cell Reference Table
  • Watch Battery Cross Reference Table
  • "IEC 60086-2 Primary batteries - Part 2: Physical and electrical specifications" (PDF).  (inc discharge characteristics)
  • "DIRECTIVE 2006/66/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL".  (407 Kb) 6 September 2006 (re recycling and disposal of batteries)

Source of the article : Wikipedia

Comments
0 Comments